Source (actual unit)
Dardomania is a dart throwing game from Sleic. Main circuit board:
There are a few EPROMs seen with stickers. Unfortunately one of the EPROMs, marked in purple, is behaving erratically. Upon closer inspection:
The VCC bond wire is broken. Unfortunately it's not just snapped but rather has balled up. This implies it melted from excessive current and the die itself may be damaged. If this is the case the data may still be there but it would beyond our current capabilities to extract.
So how can we show the chip is still salvageable?
- Run small test currents through I/O ESD diodes to verify they still function. This will help find gross damage on the chip by verifying bond wires and ground is intact
- Inspect die, especially around the melted wire, for damage
- Power VCC, carefully monitoring current draw
Fortunately VSS is still intact which makes running the ESD diode test simple. It produced promising readings indicating most I/Os at least were intact.
Next we sawed off the top of the EPROM to reveal the bare die:
Unfortunately this caused 2 more bond wires to come loose and now three need to be reattached. This is believed to be caused by the new procedure using a socket. The vise didn't grip the package as firmly and led to some slop during shearing. We believe using the socket is the right direction (strengthens pins during and after shearing) but in the future need to grip the package directly even if it's socketed.
Unfortunately aluminum wires have a non-conductive oxide surface that makes repairs more difficult. For example, while silver conductive epoxy bonds well to gold it doesn't to aluminum. This leaves two primary options:
- Use wire bonder to place new wires
- Microprobe the pads
Wire bonders are finicky and if you aren't careful you can damage the chip. So we elected to probe the pads instead of attaching new wires.
Anyway, we inspected the die and didn't see anything alarming. For example here is what damaged I/O can look like:
With this out of the way, next step is to power up the chip. We probed VCC and put the EPROM into a high end chip reader that monitors for excessive current. We omitted probing the other two pins as they were just address/data. Somewhat to our surprise the read went normally: no overcurrent and plausible looking data came out!
So next we added a few more probes to get the other pins connected. This process is relatively straightforward as bond pads are relatively large ("macro") vs traditional microprobing.
Unfortunately data did not come out reliably. Fortunately data analysis indicates read errors are closer to random noise than fundamental issues. We repositioned the probes for better contact and data began reading reliably! We compared the new stable result to older reads and found all older reads are just a few bits away from the new stable version. Success!
Finally preliminary inspection of the EPROM data vs the others in the set looks reasonable. Testing on real hardware is pending and we'll post a small update once its verified.
In other news we have also started more serious microprobing but a lot more effort is required before we get usable results. We also extracted some PICs:
These include:
- Gaelco F3 Hardance (PIC16C56)
- PUZZLE ME (PIC16C54)
- Magic Card Export 94 (PIC16C54)
- Magic Card Wien (PIC16C54A)
- Bingo Roll / Turbo Bingo (PIC16C54)
- Mystery chip "unkte06" (PIC16C56)
We also tried laser glitching some PIC16F84s but were unsuccessful. We've had success in the past and believe this is a test setup issue. We'll retry in the near future with a different laser.
Enjoy this post? Please support us on Patreon or follow us on Twitter! Note: with the Indiegogo campaign over we unfortunately don't currently have a way to accept one time donations.
